Hi,
I have been playing with the i.MX28 development board but I am struggling to get my own SD card to boot my own CE 6.0 image.
Select the maximum available space and set the format to FAT32. Click apply and once it completes, exit gparted. Shut down the live session. Put the Windows CD in the drive, and let the computer boot into the setup. Go ahead and partition the whole disk as your windows partition, and format it to the file system of your choice (I prefer FAT32).
So far I have performed the following steps:
1) Built a CE image using the Freecscale BSP
2) Used cfimager to put eboot_ivt.sb onto my 2GB SD card using the -a option to create the FAT partition
3) Manually copied NK.bin from my release directory (33-34MB) onto the SD card
4) Put the SD card in the dev board (boot switches on 1001) and watched eboot debug output (freescale logo appears)
5) Pressed space to stop boot and configured eboot to boot from the SD card (and saved settings)
6) Reset the system..... unfortunately my image does not boot. The output is as follows:
Press [ENTER] to launch image stored in SD/MMC or [SPACE] to cancel.
Initiating image launch in 0 seconds.
Launching flash image ...
-BLMenu .
INFO: Using device name: 'MX2843204'
INFO: Reading NK image to SDHC (please wait)...
![Gps software for car navigation download Gps software for car navigation download](/uploads/1/2/5/0/125060828/617314505.png)
INFO: Copying NK image to RAM address 0xa0200000
INFO: Read is 100% complete
INFO: Copy of NK completed successfully
OEMLaunch called PhysAddress 0x40200000.
Download successful! Jumping to image at 0x0 (physical 0x40200000)...
BATT:4.24V
B
5
I get the BATT info a few times. What have I done wrong to prevent the system booting up correctly?
Kind regards, Mark